Ceramic Round Christmas Tree Ornaments
A round shaped ornament for you to sublimate with your own personal designs to hang on a Christmas tree.
Sold individually, in boxes of 100 and ten boxes of decorations
Comes supplied with gold thread
Glossy finish
Suitable for double sided printing
3mm thickness
Dimensions: 7cm
Can be sublimated on both sides using a 3D Vacuum Press.
This item can be sublimation printed using a swing away heat press or a 3D Vacuum press.
These items are also suitable for UV printing and Vinyl Transfers.
To get great prints every time we suggest that you press these using a thin (1.5mm thick) silicone mat to create a flush surface.
You will need to heat these ornaments 'face down' so that you are heating through the ceramic ornament and not heating the paper directly.
The order from bottom to top should be:
1: Your heat press mat
2: The thin silicone mat
3: The paper with your design
4: The ornament with printing side facing down onto paper
5: Then your heating plate on top.
PLEASE NOTE: These ceramic items may not be 100% flat as they are a manufactured product. If you order over 200 of the ceramic round decorations they will come in boxes of 200 and the decorations will come in individual polythene wallets
*Please note that the Ceramics must be at room temperature before printing.
Pressing instructions:
3D Vacuum press:
 |
 |
 |
| 270 SECONDS |
195Ā°C |
VACUUM |
Heat Press:
Further information:
The above pressing information are guide lines only as all heat presses vary from different manufacturers.
Tips and Tricks
Being a thin ceramic we recommend using a smooth silicone pad on the bottom of your heat press and using some polyester fabric as a top cover layer as well as having your pressure on the lighter side.
As always with ceramics make sure it is heated through to at least room temp before going in the press.
